239 The distance x must be between 0.25 mm and 2.5 mm depending on the degree of contamination (see the table below), otherwise it may not be used to extend the creepage. In this case, the creepage distance would be equal to the clearance, based on the example in the figure above (DIN EN 61439-1, Appendix F). Degree of contamination Smallest width x of grooves [mm] 1 0,25 2 1 3 1,5 4 2,5 Todistus ilmaväleistä, pintaväleistä ja etäisyyksistä valumassan läpi DIN EN 60670-22: DIN EN 61439-1: Välien etäisyydet eivät saa olla pienempiä kuin taulukossa 21 on kuvattu, ja ne mitataan erinapaisten jännitettä johtavien osien, jännitettä johtavien osien ja metallitulppien tai eristämättömien rasioiden ja jännitettä johtavien osien ja jalusta-asennuspinnan väliltä. Nimellinen eristysjännite [V] Pintavälit, ilmavälit ja etäisyydet valumassan läpi [mm] 130 1,5 > 130 and 250 3 > 250 and 450 4 > 450 and 750 6 > 750 8 Tarkastukset ja tarkastusmenetelmät standardien IEC/EN mukaan Teknistä tietoa Ilma- ja pintavälit arvioidaan seuraavasti: Yleinen tekninen liite
RkJQdWJsaXNoZXIy MjIxODE=